I am using the JHBServlet to connect JSJaC to OpenFire. The initial connection and sending messages back and forth works normally. However, after an idle period a remote-stream-error will occur which will terminate the connection. I am including a typical log of traffic when left idle. Each stanza contains the POST, response, HTTP response code and time of the request/response round trip.
POST: <body rid='615968' sid='C9IU2QwsMfHqHBNorotGSZxA' xmlns='http://jabber.org/protocol/httpbind' key='0c86ef70a936ee904ca9914c73a540e1717420a9' /> Response: <body xmlns="http://jabber.org/protocol/httpbind"/> 200 OK - 5.01m POST: <body rid='615969' sid='C9IU2QwsMfHqHBNorotGSZxA' xmlns='http://jabber.org/protocol/httpbind' key='af93a42c03dcb830965eb4e4681f03cd0a4de08d' /> Response: <body xmlns="http://jabber.org/protocol/httpbind" condition="remote-stream-error" type="terminate"/> 200 OK - 53.86s POST: <body rid='615970' sid='C9IU2QwsMfHqHBNorotGSZxA' xmlns='http://jabber.org/protocol/httpbind' key='700d54fb9bf5eb4a1dc3f5699d156a9f1120490d' type='terminate'/> Response: <html> <head> <title>Apache Tomcat/6.0.18 - Error report</title> </head> <body> <h1>HTTP Status 404</h1> <p><b>description</b> <u>The requested resource () is not available.</u></p> </body> </html> 404 Not Found - 52ms After 5 minutes, a time-out occurs and a new POST is made. However, after about 50 seconds, the response contains a remote-stream-error termination. It appears that the JHB session is terminated at this point, so the next request gets the HTTP 404 from Tomcat. Note that I have already set the xmpp.httpbind.client.idle to several different values but there has been no change to the behavior. So, what is going on here? Why is the remote-stream-error occurring and better yet, how can I fix it? I have used the binding that comes in OpenFire and have not had this type of problem. After a time-out, a new connection is made and it runs normally. I am not using the built-in OpenFire binding because I was hoping to modify the JHBServlet code to handle other tasks. If necessary, I will revert to using OpenFire binding on port 7070, but I would like to know what is going on with JHB. TIA, Mike